Auto parts, aircraft high-speed rail case
After softening automotive interior parts, press the molding tunnel furnace drying line
ⅠThe main technical parameters of drying line of the tunnel furnace after softening automobile interior decorations
1、Technological process：
1.Production：ECOCOR plate，sizeL1100*W880mm；
2.Technological process：ECOCOR plate dying in the oven to 120 s,reach to 200 ' 3 ℃, the heating zone has four stations put hemp board.
3.Feeding and taking: feeding and taking by mechanical hand.
4.Feeding area ECOCOR plate transport deviation ± 2mm
5.Inner size：Heating zone length: 5600* feed inlet height: 100* inner tank width: 1300mm;
6、Dimension（around）： L8000*H1530*W1800mm；feeding area1200mm，heating area5600mm，discharge area1200mm；The conveyor belt is high off the ground 900mm
temperature range：indoor temperature～'320℃；
temperature fluctuation：±1℃；
Furnace temperature difference：±3℃；
Heating rate：10℃/min
Shell temperature：No more than the environment temperature ' 15 ℃, juncture place around.
Hot air circulation mode: circulation of large air on three sides, top out and bottom back;
Power supply: three-phase five-wire system，380V，50HZ；
Power：80KW；
ⅡThe structure characteristics of the drying line furnace of the tunnel furnace after softening the automobile interior decoration
1、Shell material: it is made of 2.0mm Q235 cold-rolled steel plate with the best strength, plasticity and welding comprehensive performance.
2、Inner material: made of 1.5mm thick SUS304 stainless steel plate;
3、Foot cup: equipped with adjustable foot cup, which is convenient to adjust the height and level of the chamber;
Ⅲ The control system of drying line of tunnel furnace after softening automobile interior decoration is pressed
1、 Air transport motor: 6 Siemens air transport motors with 0.75kw;
2、Air conveying windwheel: 1 piece of 10.5-inch stainless steel air conveying windwheel for each motor, 6 pieces in total;
3、Heating pipe: adopt u-type heating pipe of SUS304 stainless steel made in Taiwan, with radiator fin, which can make the temperature of heating pipe evenly distributed;
4、Speed control: 750W schneider servo motor, frequency control with Taiwan adly inverter, digital display panel, adjustable transmission speed of 15m-28m/min
(about 5S can be transported to the next station);
Ⅳ The environment condition of drying line of tunnel furnace after softening automobile interior decoration
1、Enviroment temperature：0℃-40℃；
2、Relative humidity：85%RH；
3、Power supply：AC380V±10%，50Hz；
