Your Location:Home > Customer Case

Successful cases of battery capacitor industry

Capacitor industry oven   

Main technical parameters of industrial oven in capacitor industry   

1、Inner dimension:W605*H130*D686mm( 8 cases)SUS304;   
2、Dimensions(around):W3440mm*H2440mm*D890mm(Do not contain cylinder),   
A total of 4 tanks can independently control the temperature, and the convenience of maintain and maintenance of the original components of the chamber should be fully considered.   
3、Temperature Range:Indoor'10℃~100℃;   
4、Temperature fluctuation:±1℃;   
5、Temperature uniformity:±5℃(Under constant temperature, no load test) (Temperature measuring point mold surface);   
6、Heating rate:Complete within 15 minutes from room temperature to working temperature   
7、Body temperature:Temperature rise does not exceed the environment'15℃,Except around the joint。   
8、Hot air circulation mode:Top air outlet, bottom side air return (wind speed 0.8m/s), wind set and heating module to be quickly replaced and repaired;
9、Power supply:Three-phase five-wire system,380V,50HZ;
10、Power:45KW;

Characteristics of industrial furnace structure in capacitor industry

1、Housing Material:2.0mm;Bending by 2.0mm cold plate, phosphating surface, high temperature electrostatic spraying treatment, corrosion resistant and easy to clean

2、Sealing material:The sealing strip is made of high temperature resistant silica gel. It can withstand temperature without deformation

3、Automatic drawer:Each inner bladder is divided into 2 drawers up and down, a total of 8 drawers (drawer is pushed out with front repeat positioning accuracy ' 0.5mm).

4、Automatic door:The upper and lower 2 layers of each inner tank are equipped with 1 set of automatic small doors. The door adopts SMC with rod cylinder and slide rail automatic control, and the cylinder is installed under the oven up and down

5、Equipped with adjustable foot cup (M20 with anchor hole, diameter of 100, no rubber pad), easy to adjust the height and level of the box

Ⅲ Industrial oven control system of capacitor industry

1、The air motor:Equipped with 1.5kw dongyuanyun air motor 4;

2、Wind turbine:Each equipped with a 10.5-inch stainless steel air wheel

3、Heat pipes:Adopt U type heating pipe of SUS304 stainless steel made in Taiwan, with heat sink, the temperature of heating pipe can be distributed evenly

Environmental conditions of industrial oven in capacitor industry

1、the ambient temperature:-10℃~~'45℃

2、Relative humidity:85%RH

3. Air source: air pressure: 4 ~ 7Bar

4、Power supply:AC380V±10%,50Hz

Industrial oven training for capacitor industry Free technical training
Successful cases of battery capacitor industry